2006 GMC Canyon
Mileage
112,264
Service Date
9/8/2022
Services Performed
- STATE INSPECTION PASS OR FAIL
- EXEMPT EMISSION INSPECTION
- Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Preform basic safety inspection.
- BALANCE TIRES
- CHECK BRAKES FOR WEAR AND CONDITION
- DIAGNOSE
- DIAGNOSE, HAS NO GROUND. REROUTE NEW GROUND WIRE
- CHECK TRANSMISSION FLUID FOR CONDITION
- CHECK EXHAUST FOR INSTALLATION FOR DUALS
- CHECK ENGINE AIR FILTER
- LICENSE PLATE BULB – Remove & Replace BOTH SIDES
- PARKING BRAKE CABLE – Remove & Replace – Rear,Left
- BRAKE SHOES &/OR PADS – Remove & Replace – Rear,Shoes – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
- CALIPER – Remove & Replace – Both – [Includes: Perform ABS Automated Bleed procedure.] – [Includes: Bleed System and replace Pads (if necessary).]
- (Combination) – BRAKE HOSE – Replace BOTH FRONT Additional – [Includes: Perform ABS Automated Bleed procedure.]
- CLEAN AND LUBE K&N AIR FILTER
- THERMOSTAT – Remove & Replace – [Includes: R&I Fender Liner.]
- CANISTER VENT SOLENOID – Remove & Replace
- WHEEL BEARING – Remove & Replace – 4WD Front,One RIGHT- [Includes: R&I Steering Knuckle and Hub Assembly.] – [Includes: Repack and adjust Bearings (where applicable).]
- MAKE AND INSTALL DUAL EXHAUST AND REMOVE SPARE TIRE CARRIER
JOHN P. gave our service a 5 star review on 9/14/2022